Forum Discussion

Marco's avatar
Marco
Contributor II
7 months ago

Dimensions: how to link an entity to a new UD5

Hi everyone. I would like to see in which section I should put the name of the UD5 in an entity, since I see that it has a section for that but in the text part I see that other configurations also...
Application Properties
  • aformenti's avatar
    aformenti
    7 months ago

    HI Marco ,

    The connection should be in the Entity Defaults fields:

    IN this example, Vendor1A will be the Default Entity member for UD5. You will then use:

    That can be used either in Calculations or Reports.

    Hope that helps, 

aformenti's avatar
aformenti
Contributor II
7 months ago

HI Marco ,

The connection should be in the Entity Defaults fields:

IN this example, Vendor1A will be the Default Entity member for UD5. You will then use:

That can be used either in Calculations or Reports.

Hope that helps, 

  • Marco's avatar
    Marco
    Contributor II
    7 months ago

    So in the UD5 it is not assigned to one created, for example to the following one I just added

     

    • aformenti's avatar
      aformenti
      Contributor II
      7 months ago

      No, in the UD5 you will need to use U5#EntityDefault, which will be a pointer of the Member you have assigned into the Entity Default field of the Entity. 

      • Marco's avatar
        Marco
        Contributor II
        7 months ago

        I see that in EntityDefault you can't modify something, how does this part work?