Forum Discussion

adriaans's avatar
adriaans
New Contributor II
2 years ago

Application Reports blank

Hi there,  After having loaded data through the Corporate Finance Data Review workflow step to the 2023Bud1 Scenario for the full year 2023, I was hoping to use the OS provided Application Reports d...
Reports
MikeG's avatar
MikeG
Contributor III
2 years ago

Navigate to the Global Options and make sure you have a default Cube Root Workflow profile set on the RPTA Settings management page.  Lastly, there are numerous reports in RPTA that (by default) are Administrator only.  Are you an Administrator in the application?  You can change that to Everyone, but best practice would be to create a new Security Group such as SG_RPTA_Report_Viewers and assign that Security Group throughout the RPTA solution.  Then that group and users will show up on your Security Audit reports.

  • adriaans's avatar
    adriaans
    New Contributor II
    2 years ago

    Hi Mike, 

    Thanks again for your response. This was indeed not set on our side, so that partially resolved the issue, although it's still a bit hit and miss on the reports. When there are intersection errors in the load and I run the Data Validation, Intersection Errors report, it returns the relevant data in the report when selecting my Workflow Profile. However, on the Import Detail (Source to Target) report group and report I select my workflow, scenario and time it returns nothing. I've included screenshots of my WF and the report. Could be that the report only works on GL imported data (the source is CSV) but unless I've missed it the documentation doesn't specify it has to be a Connector data source, rather than a Delimited File.

    Thanks, 
    Adriaan