Forum Discussion

BenvanBergen's avatar
BenvanBergen
Contributor
2 years ago

Read Only for a specific entity/scenario

Hello, Struggling today with a simple input form. For any entity I can write data, but not for 1 exception. I tried in workflow, or separate cubeview with varying dimensions which all worked before....
Forms
  • BenvanBergen's avatar
    BenvanBergen
    2 years ago

    Our consultant found it. Whenever an entity is assigned (anywhere) to a WF (so entity assignment) then the Forms input WF steps must also be True (if any inputs needs to be made anywhere). In this case you are doing a Central input on a Central WF (with no entity assignments as you can only assign it to 1 WF) but there are Country/Plant WF’s where the entities were assigned. In that case the entity WF needs then one of the Forms WF steps for that Scenario Type (Model) to be set to True ProfileActive.

    Best regards

    Ben

db_pdx's avatar
db_pdx
Valued Contributor

Two things come to mind: check that the entity is not inadvertently set to In Use = False for this scenario type.  As well, check the Data Cell Access to see if there are any rules that would prevent you from entering data for this intersection (Application > Cubes > Select your Cube > Data Access).

BenvanBergen's avatar
BenvanBergen
Contributor
2 years ago

Our consultant found it. Whenever an entity is assigned (anywhere) to a WF (so entity assignment) then the Forms input WF steps must also be True (if any inputs needs to be made anywhere). In this case you are doing a Central input on a Central WF (with no entity assignments as you can only assign it to 1 WF) but there are Country/Plant WF’s where the entities were assigned. In that case the entity WF needs then one of the Forms WF steps for that Scenario Type (Model) to be set to True ProfileActive.

Best regards

Ben