"Detail Cache summarization did not produce any Summary Data Rows" error

AndreaF
Contributor III

Hi, I am working on an Import/Validate/Load step and built a Connector which gets data from an Application table and a Data source which use the said connector.

The connector/Data source seem to work in the sense that that gets pulled in during the import step.

pci1.png

However, when the import step is run I receive the following error: "Summary: Detail Cache summarization did not produce any Summary Data Rows."

 

Does any of you know what could cause the issue and what the error message means?

Thank you

 

1 ACCEPTED SOLUTION

AndreaF
Contributor III

The issue was that all the source accounts that were pulled in to the Import table are set to Bypass for the particular workflow I was testing. Other workflow, where I have source account mapped to a valid target account, work fine!

View solution in original post

1 REPLY 1

AndreaF
Contributor III

The issue was that all the source accounts that were pulled in to the Import table are set to Bypass for the particular workflow I was testing. Other workflow, where I have source account mapped to a valid target account, work fine!