Forum Discussion

WillVitale's avatar
WillVitale
Contributor
9 months ago

Scenario Type 3 Not Showing Up in Workflow Profile

Hello, I created a new Scenario and assigned it as ScenarioType 3. I went into Application Properties and made sure ScenarioType2 general and dimensions were set up for it. I then went into the Wor...
Workflow
  • Noemi's avatar
    Noemi
    9 months ago

    Hey Will, I can see that on your first screenshot you are looking at a workflow profile under the Consol_ACT Cube Root WF profile but on your cube setting the suffix assigned to Scenario Type3 is AUD. If you want to see ScenarioType3 on a WF profile under the _ACT you need to assign the same suffix. Otherwise you can create a new cube root WF profile (Consol_AUD) and create a new WF profile under that and your ScenarioType3 will be there.

JackLacava's avatar
JackLacava
Honored Contributor
9 months ago

Make sure you refresh the application (the big white/green refresh icon on the top bar) and then refresh the Workflow Profiles page (close and reopen, or the small refresh icons on the middle bar).

Also, you're looking at a Cube Root Profile with a suffix (_ACT), so make sure you've added that suffix to your ScenarioType3 in Cube Properties.

  • WillVitale's avatar
    WillVitale
    Contributor
    9 months ago

    Hey Jack,

    I tried that before and still got nothing, so maybe I'm missing something else?

    I went in the Cubes and went into Cube Properties and Cube Dimensions to make sure everything was set up for ScenarioType3 and still nothing is showing up. Any other thoughts?

    Will