Forum Discussion

Marco's avatar
Marco
Contributor II
7 months ago

Dimensions: how to link an entity to a new UD5

Hi everyone.

I would like to see in which section I should put the name of the UD5 in an entity, since I see that it has a section for that but in the text part I see that other configurations also, so I would like to know where to put it so that they are connected, as well as about the UD5, about where the entity should go so that it is also connected.

I do this because I want to try to make a connection equal to that of the IC with the entity

Entity

UD5

 

Application Properties
  • aformenti's avatar
    aformenti
    7 months ago

    HI Marco ,

    The connection should be in the Entity Defaults fields:

    IN this example, Vendor1A will be the Default Entity member for UD5. You will then use:

    That can be used either in Calculations or Reports.

    Hope that helps, 

  • aformenti's avatar
    aformenti
    Contributor II
    7 months ago

    HI Marco ,

    The connection should be in the Entity Defaults fields:

    IN this example, Vendor1A will be the Default Entity member for UD5. You will then use:

    That can be used either in Calculations or Reports.

    Hope that helps, 

    • Marco's avatar
      Marco
      Contributor II
      7 months ago

      So in the UD5 it is not assigned to one created, for example to the following one I just added

       

      • aformenti's avatar
        aformenti
        Contributor II
        7 months ago

        No, in the UD5 you will need to use U5#EntityDefault, which will be a pointer of the Member you have assigned into the Entity Default field of the Entity.