ContributionsMost RecentMost LikesSolutionsSet the selected cell in a Cube View Is there a way of setting the selected cell in a cube view when this is refreshed. As far as I can see this defaults to the top left data cell. It would be useful if this could be set using a busines...SolvedDynamically setting the bound parameter for a Supplied Parameter Is it possible to dynamically set the Bound Parameter of a Supplied Parameter? I have tried to use and xfbr rule to do this but the supplied parameter but this does not work. Re: Dynamically setting the bound parameter for a Supplied Parameter Yes, that sounds like a problem. Was the component added only for a specific session or was this added for all users? Out of curiosity, how did you add the component? was this by updating the Dashbo...Re: Dynamically setting the bound parameter for a Supplied Parameter Thanks for the input. Unfortunately, it looks as though what I would like to do is not possible. The reason that I am thinking about supplied parameters is that this would allow parameters to be adde...Re: Dynamically setting the bound parameter for a Supplied Parameter Hi Jack. Yes, you are correct. But I think that I was a little unclear. I really meant to dynamically add a new component at run-time, such as adding a new supplied parameter to a dashboard, or a new...Re: Dynamically setting the bound parameter for a Supplied Parameter Hi Henning. Yes, I am using the on load task and also on component change. However, I have not found anywhere to set the bound parameter for a supplied parameter. Re: Dynamically setting the bound parameter for a Supplied Parameter Thanks for the input. However, I would like the assignment of the Supplied Parameter to be dynamic, i.e. the Supplied Parameter will exist in the dashboard with the name Param01 but the Bound paramet...Re: Dynamically setting the bound parameter for a Supplied Parameter Hi Jack, Thanks for the input. However, the variables that you mention change the value of the parameters and not the bound parameter that is assigned to the supplied parameter dashboard component. ...Re: security access error while uploading journal template Hi, if the journal already exists (i.e.) a journal with the same name then this existing journal needs to be rejected first.
