Forum Discussion

Nou's avatar
Nou
Contributor
3 years ago

Default load Method not sticking to replace - all time

Hi all We have come across an issue where the default load Method for workflow does not change from "replace" to "replace  all time".  Anyone has experienced the same issue? Thank you for your fee...
Workflow
PahulSharma's avatar
PahulSharma
New Contributor II
3 years ago

Hello Nouria and Marcello,

Please check sourceID which plays an important role if you are loading data. If you are using same SourceID in consecutive loads, data will always get replaced. To avoid the same, always try to use a unique SourceID. 

  • Marcello's avatar
    Marcello
    Contributor
    3 years ago

    Hi Pahul,

    I tried to change the source ids but with no results.

    1st load is statutory

     

    2nd load id bybu and "Append" method

    The result is that data is replaced.

     

    Do you think this is a bug? I am working on 6.6.0.

     

    Thanks for the help,

    Marcello

     

     

    • PahulSharma's avatar
      PahulSharma
      New Contributor II
      3 years ago

      I don't think it's a bug. Can you check if you have the same data unit on which you are loading data? That can be another reason for data replacement. To mitigate this you need to create separate channels for each load. 

      • Marcello's avatar
        Marcello
        Contributor
        3 years ago

        Hi Pahul

        yes I think separate channels need to be configured. I read the documentation and where there is a specific example on how to handle multiple loads targetting the same UD.

        I will try to configure the channels (even if it does not seem very easy) because I don't think that other solutions/workarounds are possible to make separate loads

        Thanks

        Marcello